Flood light/Tunnel lights Specification

Product Type: AL-HPTL series

1. Introduction；

We use high quality LED as light source, high light efficiency, even distribution. The lamp and cooling are integrative, avoiding the disadvantage which the tradition lamp cannot solve the heat dissipation ideally. The radiator main body takes with the high thermal conductivity’s aluminum. We use the constant voltage and constant current to make sure the lamp can work steady and long-time in different environment. Energy saving can reach 60%.

Humanized design reflects the modern fashion aesthetic reqirements of industrial illumination and the idea of humanity fully hamonious concept, instant start, no glare,no noise, internal high effeciciency(95%)heat protection system. Even the voltage is unsteady, the constant current drive can still guarantee  the light works regularly.

 2. Application:

The products are mainly applied in the tunnel: the introduction section, the transition section, the basic section and the export section.

3. Product photos:

4. Product size:

5.Specification:

6. Distrubution of light diagram

A. .AL-HPTL-80W

7.packing photo

8. product installation

Attention:

1, before installing and use,please the careful reading and operating manual, observe operation direction

2. This equipment only installs by specialist, the laymen do not disassemble or install this equipment.

Steps:

1.When connection installment or rhe disassemblage service, must separate the power source.

2. Connectted the power line

3. The lamps mounted on poles and tighten the screws that the installation is completed.